HANNAH

Wig Specification:

-24” Wavy Synthetic Lace Frontal Wig

-Chestnut Brown/Black

-13X4 Lace Front Wig and 5X5 Closure Wig available

-Swiss Lace

-Pre-plucked

-Free part (Can be worn with a left, right or middle part)

-180% density

-Heat resistant (Up to 220 degrees Celsius)

-All wigs can be washed

Follow the steps to Wash and Maintain your wig:

1. Brush your wig from the ends to the roots.

2. Run water into a basin/a container. (Use warm water as hot water can cause tangling)

3. Pour some shampoo into the warm water.

4. Dip the wig into the water and gently massage any glue or oil products off.

5. Squeeze the water from the wig. (Try not to scrub the wig as it can cause tangling)

6. Pour out used water and refill the basin/container with warm water and then repeat step 4.

7. Using a Denman brush, brush the wig from the ends to the roots.

8. Section the wig and blow dry each section on low or medium heat. Alternatively, you can air dry the wig in a towel.

9. Loosely put the sections in rollers to restore the wave pattern.

10. Steam each roller.

11. Place a thermal bag over your wig and steam it into the bag in order to trap the heat. (Complete this step for 10 minutes)

12. Leave for an hour and then remove the rollers and then run your fingers through the waves.

PLEASE NOTE: You can skip the steam steps (step 10-11) and leave the wig to air dry if you prefer. However, steaming is advised for better quality.